1在清洗过程中，要注意很多地方，禁止导电液体（如水）从超声波控制柜顶部的进气口进入。否则会对清洗机的电路系统造成严重损坏。

During the cleaning process, it is important to pay attention to many areas and prohibit conductive liquids (such as water) from entering the air inlet at the top of the ultrasonic control cabinet. Otherwise, it will cause serious damage to the circuit system of the cleaning machine.

2不使用时，保持机器清洁并关闭电源。

When not in use, keep the machine clean and turn off the power.

3我们的机器不是耐碰撞的产品，所以在使用时要避免碰撞或剧烈振动。

Our machine is not a collision resistant product, so it is important to avoid collisions or severe vibrations during use.

4我们应该让机器远离高温热源。

We should keep the machine away from high temperature heat sources.

5同时，我们应该避免把机器放在潮湿的环境中。

At the same time, we should avoid placing the machine in a damp environment.

6机器的连续工作时间不得超过4小时。例如，关闭超声波按钮，让散热器风扇继续工作。当超声波清洗未开始时，应连续冷却超声波控制柜2-3分钟。

The continuous working time of the 6 machines shall not exceed 4 hours. For example, turn off the ultrasonic button to allow the radiator fan to continue working. When ultrasonic cleaning has not started, the ultrasonic control cabinet should be continuously cooled for 2-3 minutes.

7对于长时间运行的清洗机，关机前应将电源旋钮调0，工作3-6分钟后关闭风扇，使电源内部热量散失。

For a cleaning machine that has been running for a long time, the power knob should be turned to 0 before shutting down. After working for 3-6 minutes, the fan should be turned off to dissipate internal heat from the power supply.

8清洗液应及时沉淀、过滤或更换，确保清洗效果。

8. The cleaning solution should be precipitated, filtered or replaced in a timely manner to ensure the cleaning effect.