Ultrasonic cleaning equipment not only has good cleaning effect, but also has low cost, which makes the product widely used. In order to make the cleaning more effective, let's learn what to pay attention to when cleaning.

一、留意把握应用频率

1、 Pay attention to the application frequency

超声波清洗设备在应用时，它的频率留意要在生产厂商说出示的使用手册提议的范畴以内，不可把频率调为很大或较小开展清理，以防上时间对该超声波清洗机导致损害。另外，超声设备的超声波频率较高时便会使液体内形成的汽泡规格减少，那样会使清理抗压强度也相对变弱。因而，超声波清洗机生产厂家提议选用中等水平频率清理为好。

During the application of ultrasonic cleaning equipment, its frequency shall be within the scope proposed in the user manual presented by the manufacturer. It is not allowed to adjust the frequency to large or small for cleaning, so as to prevent damage to the ultrasonic cleaning machine in time. In addition, when the ultrasonic frequency of the ultrasonic equipment is high, the bubble size formed in the liquid will be reduced, which will make the cleaning compressive strength relatively weak. Therefore, the manufacturer of ultrasonic cleaning machine proposes to use medium frequency cleaning.

二、留意运作时间

2、 Pay attention to the operation time

超声波清洗设备的运作时间要留意操纵适当，一般来讲，超声波清洗设备不应该持续好几个钟头运作。由于该机器设备较长的运作时间很有可能会导致机器设备内部的网纹辊表层及其网穴壁导致损害。另外，留意在超声波清洗机完毕运作以后，应当将调整按键归到零位。除此之外，提议客户应用超声波清洗设备以前将较难清理的零件历经预备处理系统软件解决后，再放进超声设备中清理为宜，那样机器设备运作时间大幅度减少。

The operation time of ultrasonic cleaning equipment should be properly controlled. Generally speaking, ultrasonic cleaning equipment should not last for several hours. Due to the long operation time of the machine and equipment, it is likely to cause damage to the anilox roll surface and its mesh hole wall inside the machine and equipment. In addition, note that after the operation of the ultrasonic cleaning machine, the adjustment button should be set to zero. In addition, it is suggested that before the application of ultrasonic cleaning equipment, the parts that are difficult to clean should be put into the ultrasonic equipment after being solved by the preparatory processing system software, so that the operation time of the machine and equipment will be greatly reduced.

三、留意查验清理的商品

3、 Pay attention to check the cleaned goods

超声波清洗设备清理的实质并不是靠震动来做到清理的目地，震动只是是超声波换能器在工作中时需造成的副产物。超声波清洗对质量密度越高的被清理物能造成共震的实际效果，因此要是是没有暇疵的物件，一般的微震不容易造成不好影响。

The essence of ultrasonic cleaning equipment cleaning is not to achieve the purpose of cleaning by vibration. Vibration is only the by-product of ultrasonic transducer in work. The higher the mass density of the object is, the higher the effect of ultrasonic cleaning is. Therefore, if there are no defects in the object, the general micro shock is not easy to cause bad effects.