服务热线电话

400-6188-756

通过式清洗机如何进行维保

来源:http://www.sinokohl.com/ 时间: 2025-09-17 浏览次数: 0

图2  清洗机是一种同时能清洗和干燥的设备,整个清洗过程是程序化操作,使用起来非常方便;同时也能降低能源的消耗和玻璃仪器的破损率;能保证有效的清洗能减少交叉污染和提高实验的可靠和真实的数据。

  A cleaning machine is a device that can clean and dry simultaneously. The entire cleaning process is programmed and very convenient to use; At the same time, it can also reduce energy consumption and the damage rate of glass instruments; Ensuring effective cleaning can reduce cross contamination and improve the reliability and authenticity of experimental data.

  整个清洗过程大概分为:预洗、清洗、漂洗、最终漂洗、和干燥,在每个阶段的时间和温度都可以调整,清洗机本身带有标准操作程序,同时用户根据所清洗的物品进行程序化设定,并可以经过验证后设为标准程序。

  The entire cleaning process can be roughly divided into pre washing, cleaning, rinsing, final rinsing, and drying. The time and temperature at each stage can be adjusted. The cleaning machine itself comes with a standard operating procedure, and users can program it according to the items being cleaned, which can be validated and set as a standard procedure.

  随着清洗机长时间使用,清洗机内零部件磨损积垢,长期不进行维护极易造成化学清洗泄露严重,干燥过滤器脏容易被堵,蒸汽疏水器堵升温慢、温度压力模拟量零点漂移误报警等情况。

  As the cleaning machine is used for a long time, the internal components of the cleaning machine wear and accumulate dirt. Long term lack of maintenance can easily lead to serious chemical cleaning leaks, dirty dry filters that are prone to blockage, slow heating of steam traps due to blockage, and false alarms due to temperature and pressure analog zero drift.

  实验室中常用的清洗机,随着长时间净置尘埃悬落,导致过滤效果下降,微生物易超标,无法保证清洗效果;电磁隔离阀膜片结垢,阀门漏水,膜片内漏,微生物滋生影响清洗效果;腔室清洗架密封磨损,造成密封泄漏,影响清洗效果等。

  The commonly used cleaning machines in the laboratory, with prolonged exposure to dust, result in a decrease in filtration efficiency, and microorganisms are prone to exceed the standard, making it impossible to ensure cleaning effectiveness; The fouling of the electromagnetic isolation valve diaphragm, valve leakage, internal leakage of the diaphragm, and the growth of microorganisms affect the cleaning effect; The sealing of the chamber cleaning rack is worn, causing seal leakage and affecting the cleaning effect.

  常见维保内容有:

  Common maintenance contents include:

  1.高效过滤器定期更换

  1. Regularly replace high-efficiency filters

  2.DOP完整性检漏测试

  2. DOP integrity leak testing

  3.初效过滤器定期更换

  3. Regularly replace the primary filter

  4.电磁隔离阀清洗、更换

  4. Cleaning and replacement of electromagnetic isolation valve

  5.腔室清洗架密封更换

  5. Sealing replacement of chamber cleaning rack

  6.蠕动泵润滑

  6. Lubrication of peristaltic pump

  7.打印机头更换

  7. Printer head replacement

  02

  02

  通过式清洗机常见维保内容:

  Common maintenance contents for through type cleaning machines:

  1.高效过滤器定期更换

  1. Regularly replace high-efficiency filters

  2.DOP完整性检漏测试

  2. DOP integrity leak testing

  3.初效过滤器定期更换

  3. Regularly replace the primary filter

  4.压缩空气气管、阀岛更换

  4. Replacement of compressed air pipes and valve islands

  5.隔膜阀更换

  5. Diaphragm valve replacement

  6.UV灯更换

  6. UV lamp replacement

  7.门密封更换

  7. Door seal replacement

  03动物笼清洗机常见维保内容:

  03 Common maintenance contents of animal cage cleaning machine:

  1.电磁隔离阀更换

  1. Replacement of electromagnetic isolation valve

  2.滚轮更换

  2. Roller replacement

  3.加热盘管清洗除红锈

  3. Clean and remove red rust from the heating coil

  4.蠕动泵泵头更换

  4. Replacement of peristaltic pump head

  针对以上三种清洗机类型维保总的来说可分为两大项:

  Overall, maintenance for the three types of cleaning machines can be divided into two main categories:

  1.首先确认清洗机的型号种类,依据型号查看对应的关键部件诊断清单。将可能存在问题的节点及部件逐一排查,确定清洗机整体情况,更换过滤器、清洗喷淋臂、更换何处O型圈、更换蠕动泵硅胶管等。

  Firstly, confirm the model and type of the cleaning machine, and check the corresponding diagnostic list of key components based on the model. Inspect the nodes and components that may have problems one by one, determine the overall condition of the cleaning machine, replace the filter, clean the spray arm, replace the O-ring, replace the peristaltic pump silicone tube, etc.

  2.其次进行电气测试、三相电测试、单相电测试、IO测试、测试屏幕、测试打印机、温度校准复核以及压力校准等,确认维保之后清洗机正常运作,并观察改进情况。

  2. Next, conduct electrical testing, three-phase electrical testing, single-phase electrical testing, IO testing, screen testing, printer testing, temperature calibration review, and pressure calibration to confirm the normal operation of the cleaning machine after maintenance, and observe the improvement situation.

  本文由 通过式清洗机  友情奉献.更多有关的知识请点击  http://www.sinokohl.com/   真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

  This article is a friendly contribution from the through type cleaning machine For more related knowledge, please click http://www.sinokohl.com/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.

联系我们

詹老师:18663767799(微信同号)

陶老师:13011716033(微信同号)

张老师:18663767790(微信同号)

:1476171179/1500705758

:jnkergs@163.com

:地址:山东省济南市济阳区创业路与启航街交叉口南40米

关注科尔

  • 扫一扫了解更多

  • 扫一扫了解更多

备案号:鲁ICP备18049717号-1  鲁公网安备37011202000628号