• 大区经理:张经理:18663767795
  • 大区经理:陶经理:13011716033
  • 技术咨询:詹经理:18663767799
  • 传真:0531-68850070
  • 地址:山东省济南市历城区工业北路58号恒大城K栋3-3109室
新闻资讯当前位置:首页-新闻资讯
    超声波清洗机规范的保养条例
    2016-12-13 16:50:34
    1:电源为交流380v。(三相四线)
    1: power for the exchange of 380V. (three-phase four wire)
    2: 先将超声波电源和清洗槽之间的信号线连接。(对号连接)
    2: connect the signal line between the ultrasonic power supply and the cleaning tank first. (Mark connection)
    3:将清洗槽内加入液体,高度约为300mm。储液箱内液体达到储液箱高度的一半即可温度40-55度最佳。
    3: the cleaning tank to join the liquid, the height of about 300mm. The liquid in the liquid storage tank can reach half of the height of the liquid storage tank, and the temperature is 40-55.
    4:将要清洗的工件放入清洗槽内,工件尽量不要直接接触底部。不要对清洗槽侧壁进行撞击。
    4: to clean the workpiece into the cleaning tank, the workpiece as far as possible not to the bottom of the direct contact. Do not impact on the side wall of the cleaning tank.
    5:设定好超声波所要工作的时间(注意时间不可为零),按下超声波的启动按钮,超声波开始工作。
    5: set the time (note the time can not be zero), press the start button of ultrasonic, ultrasonic start work.
    6:清洗时间根据工件的油污程度自行确定。
    6: cleaning time according to the degree of the workpiece to determine the degree of oil.
    7:循环过滤关闭时请将过滤出水阀门关闭。
    7: if the filter is closed, please close the filter outlet valve.
    8:定期清理清洗槽底部的油泥。
    8: regular cleaning cleaning tank bottom sludge.
    9:夏季如果长时间(7天)不使用设备应将清洗槽内的液体排放干净,冬季要保证槽内不结冰。
    9: in the summer if long time (7 days) do not use the equipment should be cleaned inside the tank cleaning, winter to ensure that the tank does not freeze.
    10:车间内如灰尘较大,应每月使用压缩空气将配电柜内的灰尘进行清理
    10: workshop, such as dust, the use of compressed air should be used to clean the dust in the distribution cabinet
    本文由超声波清洗机生产厂家提供帮助,更多的相关内容请点击: http://www.sinokohl.com我们将详情为您解答.欢迎您的光临!
    In this paper, the ultrasonic cleaning machine manufacturers to provide help, more relevant content, please click: http://www.sinokohl.com we will be the details for you to answer!