• 大区经理:陶经理:13011716033
  • 技术咨询:詹经理:18663767799
  • 地址:山东省济南市历城区工业北路58号恒大城K栋3-3110室
新闻资讯当前位置:首页-新闻资讯
    对全自动超声波清洗机使用者的要求?
    2020-4-21 11:46:53

    高压清洗机的使用频率越来越高。用户和用户应该注意当使用高压清洗机吗?使用前请先将泵拨上油。如果没有,使用前加油。确保机器在冬季使用前处于冷冻状态。它会冻结、融化冰,然后打开机器。使用时,将泵排干,并将机器放置在加热的房间内,以防止变冷。冻结的机器。

      The use frequency of high-pressure cleaning machine is higher and higher. Should users and users pay attention to the use of high-pressure cleaning machine? Before use, please put oil on the pump. If not, refuel before use. Make sure that the machine is frozen before use in winter. It freezes, melts, and turns on the machine. When in use, drain the pump and place the machine in a heated room to prevent cooling. Frozen machine.

      1. 使用本设备时,电源必须配置漏电保护开关和安全接地。它必须与插座配合好地线。输入电压必须保证其稳定。电压过低或过高都会损坏设备。一般单电源应保证220V ~ 240V电压,三台电源应保证380V ~ 400V电压。

      1. When using this equipment, the power supply must be equipped with leakage protection switch and safety grounding. It must be matched with the ground wire of the socket. The input voltage must be stable. Low or high voltage will damage the equipment. Generally, the single power supply shall guarantee the voltage of 220V ~ 240V, and the three power supplies shall guarantee the voltage of 380V ~ 400V.

      2. 输入(输入)电源线的直径不能太细或太长。一般清洗设备的电机功率,电容启动电机,启动电流。因此,钢丝的直径截面不应小于4平方米,钢丝的长度不应大于25米。电线在25米时应加厚至6平方米;否则,电会发热,不启动,甚至烧坏。

      2. The diameter of the input (input) power cord shall not be too thin or too long. General cleaning equipment motor power, capacitor start motor, starting current. Therefore, the diameter section of steel wire shall not be less than 4 square meters, and the length of steel wire shall not be more than 25 meters. When the wire is 25m, it should be thickened to 6m2; otherwise, the electricity will heat up, fail to start, or even burn out.

    全自动超声波清洗机

      3.高压清洗机严禁被车辆等重物压碎,以免高压胶管断裂。

      3. It is strictly prohibited to crush the high-pressure cleaner by heavy objects such as vehicles, so as to prevent the high-pressure rubber hose from breaking.

      4. 使用本机时,严禁将高压水喷在风机叶片位置,以免水进入电机造成漏电危险。

      4. When using the machine, it is strictly prohibited to spray high-pressure water on the position of the fan blades, so as to avoid leakage hazard caused by water entering the motor.

      5 .在使用高压冷水和热水清洗机时,除了要注意电源电压外,还要考虑使用柴油必须质量好,无杂质,不允许进水。混合起来。应根据天气和温度的变化来选择柴油机的标签。基本公式如下:在当前环境温度下为- 15。例如,当当前环境温度为0时,所选柴油标签为- 15,当环境温度为- 10度时,所选柴油标签为- 25。高压清洗机的水质应清洁,无杂质,应定期清洗滤水器。每次你使用机器时,把水泵的水放干,并把它放在一个有暖气的房间里,以防止它在寒冷中结冰。

      5. When using the high-pressure cold water and hot water washing machine, in addition to paying attention to the power supply voltage, it is also necessary to consider that the diesel oil must be of good quality, free of impurities, and water is not allowed to enter. Mix it up. The label of diesel engine shall be selected according to the change of weather and temperature. The basic formula is - 15 at the current ambient temperature. For example, when the current ambient temperature is 0, the selected diesel label is - 15, when the ambient temperature is - 10 degrees, the selected diesel label is - 25. The water quality of the high-pressure cleaner shall be clean and free of impurities, and the water filter shall be cleaned regularly. Every time you use the machine, drain the water from the pump and put it in a heated room to prevent it from freezing in the cold.

      6. 使用新机器2 - 3天后,一定要先换机油,然后再根据使用频率换。如果使用频率过高,建议每月换一次。

      6. After using the new machine for 2-3 days, be sure to change the oil first, and then change it according to the use frequency. If the frequency of use is too high, it is recommended to replace it once a month.

      以上就是对全自动超声波清洗机使用者的要求的详细介绍,想要了解多请点击官网http://www.sinokohl.com

      The above is a detailed introduction to the requirements of users of automatic ultrasonic cleaning machine. For more information, please click http://www.sinkohl.com